VONROC GT501DC Traduction De La Notice Originale page 10

EN
Only use the following batteries of the VONROC
VPOWER 20V battery platform. Using any other bat-
teries could cause serious injury or damage the tool.
CD801AA 20V, 2Ah Lithium-Ion
CD803AA 20V, 4Ah Lithium-Ion
The following charger of the can be used to charge
these batteries.
CD802AA Quick charger
The batteries of the VONROC VPOWER 20V battery
platform are interchangeable with all the VONROC
VPOWER 20V battery platform tools.
Vibration level
The vibration emission level stated in this instructi-
on manual has been measured in accordance with
a standardized test given in EN 50636-2-91; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
- Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
- The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-5.
1. Battery
2. Battery unlock button
3. Battery charge indication
4. Charger
5. Charger LED indicators
6. On/off switch
7. Safety switch
8. Front handle
9. Front handle knob
10. Protection guard
11. Screw
12. Guardrail
13. Side wheel
14 Side wheel holder
15. Spool cover
16. Spool reel
10
17. Spool spring
18. Spool housing
19. Tip spool reel
20. Adjustment knob trimmer head
21. Adjustment ring trimmer head
22. Lower adjustment ring
23. Upper shaft
24. Lower shaft
25. Battery LED indicators button
3. ASSEMBLY
Before any work on the power tool, remove
the battery.
Warning! Do not use the grass trimmer
without the protection guard.
The machine must be charged before first
use.
Inserting the battery into the machine (Fig. C1)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (1) into the base of the machine
as shown in Fig. C1.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. C1)
1. Push the battery unlock button (2).
2. Pull the battery out of the machine like shown
in Fig. C1.
Checking the battery charging status (Fig. C2)
• To check the battery charge status, push the
button (25) on battery shortly.
• The battery has 3 lights indicating the charge
level, the more lights that burn, the more charge
the battery has left.
• When the lights are not burning it means the bat-
tery is empty and must be charged immediately.
Charging the battery with the charger (Fig. C2)
1. Take the battery (1) from the machine.
2. Turn the battery (1) to upside down position and
slide it onto the charger (4) as shown in Fig. C2.
3. Push the battery until it is fully pushed into the
slot.
WWW.VONROC.COM