Accessories - Milwaukee 1854-1 Manuel De L'utilisateur

Bracing for Forward Rotation
When drilling in forward, the bit will rotate in a clock-
wise direction. If the bit binds in the hole, the bit will
come to a sudden stop and drill will suddenly react
in a counterclockwise direction.
Forward Rotation
A. Forward (clockwise) rotation
B. Reaction
C. Brace drill with pipe handle here
If the bit binds, the pipe handle or the motor housing
braced against the stud will hold the drill in position.
Bracing for Reverse Rotation
When drilling in reverse, the bit will rotate in a coun-
terclockwise direction. If the bit binds in the hole,
the bit will come to a sudden stop and the drill will
suddenly react in a clockwise direction.
Reverse Rotation
A. Reverse (counterclockwise) rotation
B. Reaction
C. Brace drill with pipe handle here
If the bit binds, the pipe handle or the motor housing
braced against the stud will hold the drill in position.
Reversing
Use the reversing switch to remove bits from holes.
Permit the motor to come to a complete stop before
reversing. Reversing the tool with the gears in motion
may cause severe damage. When removing selfeed
bits from partially drilled holes, a flick of the trigger
switch will free the threaded pilot screw. When the
threads are loose, lift the bit from the workpiece with
the motor stopped.
C
B
A
B
C
A
To reduce the risk of electric shock,
WARNING
check work area for hidden pipes
and wires before drilling or driving screws.
To reduce the risk of injury, always wear proper
eye protection marked to comply with ANSI Z87.1.
Before drilling, clamp the material down securely. A
poorly secured piece of material may result in per-
sonal injury or inaccurate drilling. When drilling in light
gauge metal or wood, use a wooden block to back
up the material to prevent damage to the workpiece.
Mark the center of the hole to be drilled with a center
punch to give the bit a start and to prevent it from
"walking." Lubricate the drill bit with cutting oil when
drilling iron or steel. Use a coolant when drilling non-
ferrous metals such as copper, brass or aluminum.
MAINTENANCE
To reduce the risk of injury, always
WARNING
unplug the tool before performing
any maintenance. Never disassemble the tool.
Contact a MILWAUKEE service facility for ALL
repairs.
Maintaining Tools
Keep your tool in good repair by adopting a regular
maintenance program. Inspect your tool for issues
such as undue noise, misalignment or binding of
moving parts, breakage of parts, or any other condi-
tion that may affect the tool operation. Return the tool
to a MILWAUKEE service facility for repair. After six
months to one year, depending on use, return the
tool to a MILWAUKEE service facility for inspection.
To reduce the risk of personal in-
WARNING
jury, electric shock and damage,
never immerse your tool in liquid or allow a liquid
to flow inside it.
Clean dust and debris from vents. Keep handles
clean, dry and free of oil or grease. Use only mild
soap and a damp cloth to clean, since certain clean-
ing agents and solvents are harmful to plastics and
other insulated parts. Some of these include gasoline,
turpentine, lacquer thinner, paint thinner, chlorinated
cleaning solvents, ammonia and household deter-
gents containing ammonia. Never use flammable or
combustible solvents around tools.
For repairs, return the tool to the nearest authorized
service center.

ACCESSORIES

Use only recommended accesso-
WARNING
ries. Others may be hazardous.
For a complete listing of accessories, go online to
www.milwaukeetool.com or contact a distributor.
6
Drilling
Cleaning
Repairs