Lindy 32446 Manuel Utilisateur page 3

User Manual
Introduction
Thank you for purchasing a splitter from the DVI-D range of products. These devices are high
performance DVI-D distribution amplifiers. They allow a DVI-D signal to be split to 2, 4 or 8 DVI-
D enabled displays or projectors for multi-screen presentation.
The DVI-D single link versions with 2 (32447), 4 (32446) and 8 (38108) output ports support
HDCP signals with resolutions up to 1920x1200 or 1080p@60Hz.
The DVI-D dual link versions with 2 (38107) and 4 (38104) output ports do not support HDCP
signals and should only be used for DVI-D dual link signals with higher resolutions up to
2560x1600.
Package Contents
 DVI-D Splitter
 5V DC PSU
 This user manual
Features
 Single link versions support resolutions up to 1920x1200 or 1080p@60Hz
 Dual link versions support resolutions up to 2560x1600
 Can be cascaded up to 3 layers depending on the cable quality
 Single link versions have a built in EDID simulator and HDCP keyset allowing each output to
operate independently. They also support HDMI signals when using appropriate cables and
adapters
Specification
 Compliant with DVI 2.0 specification
 Amplified outputs allow cable lengths of up to 15m when using DVI SLD cables
 Video bandwidth:
 Single link: 165Mhz
 Dual link: 225Mhz
Installation
 Make sure all devices are powered off before making any connections!
 Connect all cables and power supplies to the sources, switches and displays.
 Power on the displays, splitter then the source devices to avoid any connection issues.
NOTE: We recommend you do not use dual link splitters with resolutions of 1920x1200, 1080p60
or below. This may cause signal issues and lack of picture on your displays.
English