Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EXTENSION COrDS
grounded tools require a three wire extension cord
either a two or three wire extension cord. As the distance from the power supply outlet increases, you must use a
heavier gauge extension cord. using extension cords with inadequately sized wire causes a serious drop in voltage,
resulting in loss of power and possible tool damage. Refer to the table shown below to determine the required
minimum wire size.
The smaller the gauge number of the wire, the greater the capacity of the cord. for example: a 14-gauge cord
can carry a higher current than a 16-gauge cord. When using more than one extension cord to make up the total
length, be sure each cord contains at least the minimum wire size required. If you are using one extension cord for
more than one tool, add the nameplate amperes and use the sum to determine the required minimum wire size.
guidelines for Using Extension Cords
• If you are using an extension cord outdoors, be sure it is marked with the suffix "W-A" ("W" in Canada) to
indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired and in good electrical condition. Always replace a damaged
extension cord or have it repaired by a qualified person before using it.
• Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate
Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0
18
2.1–3.4
18
3.5–5.0
18
5.1–7.0
18
7.1–12.0
18
12.1–16.0
14
16.1–20.0
12
SPECIFIC SAFETY rULES FOr DrILL PrESSES
WArNINg:
FrOM rEPEATED USE) rEPLACE STrICT ADHErENCE TO PrODUCT SAFETY rULES. If
you use this tool unsafe or incorrectly, you can suffer serious personal injury!
Make sure the drill press is on a firm, level surface
•
from unexpected movement. firmly clamp or bolt the drill press to a support surface to prevent slipping or
sliding during the operation.
• Unplug the drill press before making adjustments
Always switch off the drill press
•
plugging the tool into a power source.
Use recommended speeds for drill accessories
•
Allow the motor to come up to full speed
•
Wear eye protection.
•
Before starting the operation, jog the motor switch
•
cutting tool does not wobble or cause vibration.
•
Keep hands away from work area
Be sure drill bit or cutting tool is securely locked in the chuck.
•
Always clamp work piece or brace against column
•
hand to hold the work piece while drilling.
Make sure the pulley housing cover is down
•
engaging the power switch.
Keep bits clean and sharp.
•
Lock the switch off
•
50 Feet
75 Feet
18
18
18
16
14
12
10
DO NOT LET COMFOrT Or FAMILIArITY WITH PrODUCT (gAINED
before unplugging it to avoid accidental starting when re-
Do not wear gloves, necktie, or loose clothing.
Sharp bits minimize stalling.
when leaving the drill press.
100 Feet
18
18
18
16
16
14
14
12
12
10
10
10
8
8
, repairs, maintenance or storing.
and work piece material.
before drilling to avoid binding or stalling.
to make sure the drill bit or other
. Keep hands away from the bit.
to prevent rotation. Never use your
and the chuck is installed properly before
.
Double insulated tools can use
150 Feet
200 Feet
16
16
14
14
12
12
12
10
8
8
8
6
6
6
and properly secured to avoid injury
5
Publicité
Table des Matières
