Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EXTENSION COrDS
Grounded tools require a three wire extension cord
use either a two or three wire extension cord. As the distance from the power supply outlet increases, you must
use a heavier gauge extension cord. using extension cords with inadequately sized wire causes a serious drop
in voltage, resulting in loss of power and possible tool damage. refer to the table shown below to determine the
required minimum wire size.
The smaller the gauge number of the wire, the greater the capacity of the cord. For example: a 14-gauge cord
can carry a higher current than a 16-gauge cord. When using more than one extension cord to make up the total
length, be sure each cord contains at least the minimum wire size required. If you are using one extension cord
for more than one tool, add the nameplate amperes and use the sum to determine the required minimum wire
size.
Guidelines for Using Extension Cords
• If you are using an extension cord outdoors, be sure it is marked with the suffix "W-A" ("W" in Canada) to
indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired and in good electrical condition. Always replace a damaged
extension cord or have it repaired by a qualified person before using it.
• Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate
Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0
18
2.1–3.4
18
3.5–5.0
18
5.1–7.0
18
7.1–12.0
18
12.1–16.0
14
16.1–20.0
12
SPECIFIC SAFETY rULES FOr COrDLESS OSCILLATING
TOOLS
WArNING:
(GAINED FrOM rEPEATED USE) rEPLACE STrICT ADHErENCE TO PrODUCT SAFETY
rULES. If you use this tool unsafe or incorrectly, you can suffer serious personal injury!
WArNING:
operation where cutting tools may contact hidden wiring or its own cord. Contact with a
"live" wire will make exposed metal parts of the tool "live" and shock the operator!
Always wear safety glasses or goggles.
•
glasses.
Always hold the tool firmly.
•
Check your work area for proper clearances before cutting
•
into your workbench, the floor, etc.
Do not cut nails or screws
•
Inspect your material before cutting.
Before switching on the tool,
•
Do not use tool if switch does not turn it on or off
•
by the switch is dangerous and must be repaired.
Wear cushioned protective gloves to minimize the vibration
•
cause personal injury.
Do not wet-sand with this tool.
•
shock and serious personal injury.
50 Feet
75 Feet
18
18
18
16
14
12
10
DO NOT LET COMFOrT Or FAMILIArITY WITH THE PrODUCT
Hold the tool by insulated gripping surfaces when performing an
Do not leave the tool running unless hand held.
unless you are using a blade specifically designed for this purpose.
be sure the blade is not contacting the work piece.
Water or moisture entering the motor housing can cause electric
100 Feet
18
18
18
16
16
14
14
12
12
10
10
10
8
8
Normal prescription eye or sunglasses are not safety
. Any tool which can not be controlled
.
Double insulated tools can
150 Feet
200 Feet
16
16
14
14
12
12
12
10
8
8
8
6
6
6
. This will avoid cutting
. excessive vibration may
5
Publicité
Table des Matières
