Fault Rectification - Maico TRE 0,4-1 Instructions De Montage Et Mode D'emploi

GB
Installation of the housing cover

Housing type
 Insert the 4 supplied threaded inserts [1.4]
in the housing lower part. Make sure the
inserts give an audible click as they lock
into position.
 Carefully insert the operating indicator light
in the operating indicator light holder in the
housing cover (see arrow). Take note of
the position of the two lateral locking cams.
 Set the housing cover on the housing lower
part and screw into place with the 4 fixing
screws (torque = 1.2 Nm).
 Set the control knob onto the speed
selection switch shaft.
The flattened side of the switch shaft
i
as well as the marking on the control
knob must point in the correct
direction when locating the knob.
12

Housing type
 Close the control cabinet door and lock it
with the control cabinet key.
 Push the speed selection switch control
knob [2.5] onto the shaft and secure it with
a screw.
Start-up
Install all system components in
accordance with their Operating instruction
before starting up.
 Check that the technical data has been
adhered to by reference to the rating plate.
 Switch the mains fuse on.
 Carry out a function test at all 5 speed
levels.
8. Maintenance
The unit is maintenance-free.

9. Fault rectification

● Call on the services of a trained
electrician any time there is a fault.
● Repairs should only be carried out by a
trained electrician.
Danger to life. Unit is powered
up
 Disconnect the 5-step
DANGER
transformer completely from
the power supply before
opening the transformer
housing: Switch the mains
fuse off and position a visible
warning notice to avoid the
unit being accidentally
switched back on.