Panasonic TY-SB01SS Mode D'emploi page 3

Terminals
3G SDI
IN
Input terminal (BNC)
3G-SDI/HD-SDI/SD-SDI input terminal
Active-through output terminal
(BNC)
OUT
Directly outputs SDI input.
Note
●
Use a 5C-FB cable or equivalent to connect to the
SDI terminal.
●
When performing the active-through output while the
LCD display is in standby mode, set [SLOT settings] -
[SLOT standby] of the display to [On].
● If CRCC error (page 5) occurs, check the cable to
use.
Replacing the
terminal board
The replacement instruction below is based on the
flat panel display SQ1 series as an example.
For attaching or removing this product to or from the flat
panel display unit, it is recommended to ask a qualified
technician or sales dealer. A malfunction may occur due
to static electricity, etc. Consult the sales dealer.
Follow the steps below.
Note
●
Be sure to turn off the display unit and connected
devices, remove the power plug from the socket, and
disconnect the cables from the display.
●
When attaching/removing the terminal board, do not
allow the metal to damage the back cover or display
label.
1
Remove the 2 screws, and then remove the slot
cover or terminal board from the display unit.
To remove the terminal board, hold the handle of
the terminal board and pull it out slowly in the arrow
direction.
2
Insert the terminal board to the main unit slot,
and tighten the 2 screws.
Fix the terminal board with the 2 screws removed in
step 1.
Note
● When replacing another terminal board with this
product, the customer shall keep the replaced
terminal board for future repair or servicing.
3
English