Sony MEX-M72BT Mode D'emploi page 15

Notes
• The activation process usually takes 10 to 15
minutes, but may take up to an hour.
• Your radio will need to be turned on and receiving
the SiriusXM signal to receive the activation
message.
Selecting channels for SiriusXM
1
Press (browse).
2
Rotate the control dial to select
[CHANNEL], then press it.
3
Rotate the control dial to select the
desired channel, then press it.
To select channels with rapid browse
mode
Press and hold  or  of remote
commander more than 2 seconds after
[CHANNEL] selected, then press ENTER.
To select channels from categories
1
Press (browse).
2
Rotate the control dial to select [CATEGORY],
then press it.
3
Rotate the control dial to select the desired
category, then press it.
The channel list appears.
4
Rotate the control dial to select the desired
channel, then press it.
To store channels
1
While receiving the channel that you want to
store, press and hold a number button (1 to
6) until [MEM] appears.
To receive the stored channel, press MODE
to select the Band you want ([SX1], [SX2] or
[SX3]), then press a number button (1 to 6).
(Each Band can store up to 6 channels.)
To set a parental control
The parental control feature allows you to
limit access to SiriusXM channels with
mature content. When enabled, the parental
control feature requires you to enter a
passcode to tune to the locked channels.
Information on setting up the passcode and
locking channels can be found below.
1
Press MENU and rotate the control dial.
Select [GENERAL]  [SXM PARENTAL] 
2
[LOCK SELECT]  [LOCK-ON].
3
Enter the passcode by rotating the control
dial on the unit or pressing / on the
remote commander.
To move the entry position, press /
(SEEK –/+) on the unit or / on the remote
commander.
The initial passcode is [0000].
4
After entering the passcode, press ENTER.
To unlock the channels, select [LOCK-OFF].
To change the passcode
1
Press MENU and rotate the control dial.
Select [GENERAL]  [SXM PARENTAL] 
2
[CODE EDIT].
3
Enter the current passcode on the current
passcode input display, then press ENTER.
The initial passcode is [0000].
4
Enter your new 4-digit passcode on the new
passcode input display, then press ENTER.
To change display items
Press DSPL to change as follows:
Channel Number (Default)  Channel Name
 Artist Name  Song Title  Content Info 
Category Name  Clock  Battery Voltage
15
GB