Operations; Setting The Operating Level; Improving Bass Sound - Clarion XH5210 Mode D'emploi Et Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. OPERATIONS

Selecting input voltage
XH amplifiers accommodate a wide range of signal input voltages (0.V to 8V). This
wide range is split up into three ranges, which are accessible through
switches located in the "Gain" area of the amplifier.
• 0.V-0.V selects an input sensitivity range between 00mV and 00mV.
• 0.-V selects an input sensitivity range between 00mV and V.
• V-8V selects an input sensitivity range between V and 8V.
The gain rotary control operates within these voltage windows.
Note:
Most decks, even 4V and 5V units do not operate at full output voltage.
This requires the switch to be set in the 0.6-2V range.

Setting the operating level

The gain switches allow you to set the nominal operating level of the amplifier from
0. to 8V for RCA inputs or 500mV to 5V for speaker level inputs. This wide adjust-
ment range accommodates virtually any source unit brand.
Once you set the correct range using the IVS, you must adjust the gain to match the
amplifiers sensitivity to that of the source unit. The gain control is not a volume con-
trol. It exists only to allow an amplifier to be used with different models and brands of
head units.

Improving bass sound

The amplifiers feature a narrow-frequency band bass boost circuit (known as "high-
Q"). Acting much like an equalizer, the bass boost control lets you tune low-frequen-
cy audio response to compensate for a less than ideal subwoofer enclosure design.
The added boost produces rich, full bass tones that are normally difficult to repro-
duce in the car audio environment.
• The XH510 and XH5410 have a switchable gain that is fixed at 45Hz. If you
don't want to boost the bass frequencies, set this control to "OFF."
• The XH7110 has a variable-frequency bass boost control from 0Hz to 15Hz.
It does not have a bass boost on/off switch, but a level control that goes from
0dB to 15dB.
This control can dramatically increase the power output level
and could cause speaker damage if you over use it.
8
XH510/XH5410/XH7110
CAUTION

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Xh5410Xh7110Xh série

Table des Matières