Clarion XH5210 Mode D'emploi Et Manuel D'installation page 16

Two-channel full-range or subwoofer system (XH5210)
In this application, the XH510 is used to drive two speakers.
Subwoofer in stereo
• Set crossover mode switch to LP
• Set crossover frequency to ~80Hz
• Fine-tune as required
• Ω min stereo / 4Ω min mono
Full-range speakers or components in stereo
• Set crossover mode switch to OFF
Components speakers in stereo with separate subwoofer amp
• Set crossover mode switch to HP
• Set crossover frequency to ~00Hz for 4-inch speakers
Subwoofers and component speakers at the same time
• Set crossover mode switch to OFF
• Install passive crossovers on subwoofers (inductor) and components (capacitor)
1
XH510/XH5410/XH7110
Subwoofers
Full-range co-axial or
Component speakers
~100Hz for 5.5-inch speakers
~75Hz for .5-inch speakers
~5Hz for  x 9-inch speakers