Kidco Auto Close Hearth Gate Guide D'utilisation page 4

Auto Close Heart hGate
U S E R G U I D E G3111
Installation
NOTE: Move HearthGate to desired location.
Sections may need to be adjusted again for
proper fit.
12
Lift locking caps and rotate upper and
lower wall brackets until flush against
mounting surface and lower bar housing is
aligned with the upper bracket assembly.
NOTE: Sliding wall bracket assembly is
adjustable for uneven walls and should be
installed as low as possible.
13
With a pencil, lightly outline brackets on
mounting surface.
14
Remove wall plates from brackets by
pressing locking tabs and sliding up.
15
Hold one wall plate with arrow facing up
inside pencil outline and install using two
wood screws. Repeat for all other wall
plates. NOTE: Screws provided are for
mounting directly into wood. If mounting into
brick, drywall or other surfaces, use
appropriate hardware.
16
Attach gate to wall plates by aligning
arrows and inserting round tabs into wall
plates (a). Slide down to lock (b). Tighten bolts
on sliding wall brackets. Gate should now be
properly installed.
6
™
12
13
14
15
16
(a)
(b)
G3111
17
(b)
(a)
18
90º
19
(a)
20
Auto Close Heart hGate
U S E R G U I D E
™
Operation
17
Slide back the locking button (a) and lift
door to open in either direction (b). Door will
automatically close and the lock will
re-engage with an audible "click".
NOTE: The door section must be placed on a
level surface for the auto close function to
work properly, if not, the door will need to be
manually pushed shut. Test auto close
function before use.
18
Hold Open Feature – By opening the door
to a 90º or greater angle, it will stay open
until it is pushed closed.
Removal
(b)
19
To remove gate from wall press locking
tab on the lower wall bracket assembly
sliding it up and off the wall plate (a).
Repeat the process on the upper wall
bracket assembly and remove entire gate
from wall (b). Repeat for other side.
Making an enclosed
play area
20
To make the HearthGate a self standing,
enclosed play area, additional sections will
need to be purchased. After assembly of all
sections connect the two ends together. Once
all sections have been assembled, adjust
them to make a desired shape.
7