Kidco Auto Close Hearth Gate Guide D'utilisation page 3

Auto Close Heart hGate
U S E R G U I D E G3111
Assembly
1
To connect two sections, place hinge
posts over the center of the next section's
hinge receivers and press down until a click
is heard. NOTE: You may need to pull up on
adjoining section. Continue adding more
sections the same way. Optional 9" and 24"
sections are available for purchase for
larger areas or to construct a free
standing enclosure.
NOTE: The walk through door section can be
positioned anywhere within the layout of the
gate. For the auto close door feature to work
properly the entire gate must be on a level
floor surface, otherwise the door may have
to be manually pushed shut.
2
Once all sections have been assembled
lift all locking caps into the raised unlocked
position (a) and adjust the angle of each
section until desired configuration is achieved
(b). Push down on all locking caps (c). If
locking cap is difficult to lift, gently rotate
sections to relieve pressure and/or carefully
insert a coin or slotted screwdriver in notch
(d) between cap and housing, and push up.
3
Insert wall mount bar into upper
post bar bracket. The wall plate is already
attached to the upper post bar bracket.
4
Insert bar into sliding wall bracket
assembly with locking tabs lined up on right
side and arrows facing up.
5
Insert bar into lower post bar housing.
4
™
1
2
(a) (c)
(d)
(b)
3
4
5
G3111
6
7
8
9
10
11
Auto Close Heart hGate
U S E R G U I D E
™
6
Attach bar assembly to receiver of end
gate section.
7
Insert wall mount bar into upper receiver
bar bracket. The wall plate is already
attached to the upper receiver bar bracket.
8
Insert bar into sliding wall bracket
assembly with locking tabs lined up on right
side and arrows facing up.
9
Insert bar into lower receiver bar
housing.
10
Attach bar assembly to post end
gate section.
11
NOTE: To remove a section, place
thumb and index finger on ribbed tabs
inside upper hinge post and pinch
while lifting.
5