Filling Water Tank; General Operation - McCulloch MC1245 Mode D'emploi

FILLING WATER TANK

NOTE: This unit features a continuous-fill Water Tank. It does not require any cool down
period before refilling.
1. Unplug unit before filling the Water Tank.
2. Remove Water Tank Cap by pulling up on cap.
3. Using funnel, fill Water Tank with 10 oz. (295 ml) of water.
NOTE: While this unit will function correctly using ordinary tap water, it is recommended
that distilled or de-mineralized water be used instead. This will help to minimize mineral
build-up in the unit and prolong the life of your Rotary Action Steam Cleaner.
4. Once Water Tank is filled, replace Water Tank Cap.
5. To assure water feed pick up ball is in the water, shake the unit vigorously to move ball into
water. Once dislodged, you will be able to hear the ball moving loosely.

GENERAL OPERATION

NOTE: Unit will not emit steam without properly installing the Water Treatment Car-
tridge. Do not operate unit without water. Be sure that any desired attachments are con-
nected before following these steps.
1. Plug grounded power cord into a convenient electrical outlet (make sure to first remove plastic
cover that protects plugs during shipping). The Steam Level Indicator Lights will flash while the
unit warms up. Allow unit approximately 30 seconds to heat up.
CAUTION: This unit uses a grounded (3-prong) electrical plug. Use only in properly
installed 3-prong electrical outlets. Do not attempt to alter plug or circumvent this safety
feature in any way.
NOTE: Steam Level Indicator Light is illuminated at all times while unit is plugged in.
This unit has no On/Off power switch; it will begin heating immediately upon being
plugged in.
2. Once the unit is ready for use, the light will turn solid and default to medium (II) Steam Level.
3. Press the Rotary Action Power Button to power on/off the rotary action (See figure 1, A). The
Rotary direction changes each time the Rotary Button is powered "on".
This will help prolong the life of the brush. The rotary action can be
used without steam.
NOTE: If brush has been stopped while in rotary mode for more
than 20 seconds, the rotary motor will stall and need to be reset.
See Troubleshooting on Page 11 for instructions. The current
Steam Level Indicator Light will flash to indicate rotary motor has
stopped and steam will cease.
8 | ENGLISH
Using Your Rotary Action
Steam Cleaner
A
FIGURE 1