Storage & Care; Removing Mineral Build-Up - McCulloch MC1245 Mode D'emploi

PROPER STORAGE
Preparing your Rotary Action Steam Cleaner for storage is quick and simple. When you have
finished your steaming tasks, follow the steps listed below:
1. Unplug power cord from electrical outlet.
2. Allow unit to completely cool.
3. Remove any attachments from unit.
4. Remove Water Tank Cap and drain any remaining water from Water Tank.
5. Store all attachments safely away, preferably near Rotary Action Steam Cleaner.
6. Store Rotary Action Steam Cleaner in a cool, dry location.

REMOVING MINERAL BUILD-UP

A common problem with steam appliances is mineral build-up caused by high mineral content in
many municipal water supplies. The Water Treatment Cartridge will remove most of the minerals
from tap water but the best way to avoid this is to use de-mineralized or distilled water in unit. If
you are unable to use de-mineralized or distilled water, we recommend you use this procedure
below monthly to help avoid mineral build-up:
NOTE: Perform this procedure below before you replace the Water Treatment Cartridge.
Running vinegar through the Water Treatment Cartridge will reduce the effectiveness of
the Water Treatment Cartridge.
1. Unplug power cord from electrical outlet.
2. Allow unit to completely cool.
3. Remove all accessories from unit.
4. Unscrew Steam Outlet Tip from the Attachment Collar. Remove any
debris from Steam Outlet Tip by using a paper clip. Rinse with water
to ensure blockage is gone. Set Steam Outlet Tip aside.
5. Remove Water Tank Cap and drain any remaining water from Water Tank into sink or tub.
6. Using a measuring cup, measure 8 oz. (236 ml) of distilled vinegar.
7. Using the Funnel, slowly pour vinegar into Water Tank and replace Water Tank Cap.
8. Plug power cord into an electrical outlet and allow unit to heat up.
9. Set Steam Level Selector to high (III).
10. Hold down Steam Trigger to spray vinegar into a sink or tub. Continue to hold down Steam
Trigger until Water Tank is completely drained (approximately 8 minutes).
11. Unplug power cord from electrical outlet.
12. Using the Funnel, fill Water Tank with fresh water and replace Water Tank Cap.
13. Plug power cord into an electrical outlet and allow unit to heat up.
14. Hold down Steam Trigger to spray water into a sink or tub. Continue to hold down Steam
Trigger until Water Tank is completely drained (approximately 8 minutes).
15. This will flush out any remaining vinegar solution in unit. Repeat steps 11-14 until vinegar
odor dissipates.
10 | ENGLISH
Storage & Care
Steam
Outlet Tip