McCulloch MC1245 Mode D'emploi page 11

16. Reinstall Steam Outlet Tip
17. Dispose of old Water Treatment Cartridge and replace with new one.
Water Treatment Cartridges may be ordered online at steamfast.com or contact Consumer
Service at 1-800-711-6617.
PROBLEM
Unit fails to heat up.
The unit is heated, but does not
produce steam.
The unit is hot to the touch.
Note: The unit will be warm during
use.
Steam output is intermittent.
Rotary motor has stalled.
Storage & Care
Troubleshooting
POSSIBLE CAUSE
Unit is not plugged in.
Household Circuit Breaker /
Ground Fault Interrupter has
tripped or blown a fuse.
Water Tank is empty.
Mineral build-up in unit.
Water Treatment Cartridge is not
installed correctly.
Water feed pick up ball is not in
water.
Water Tank is empty.
Mineral build-up in unit.
Too much force has been put on
brush.
SOLUTION
Plug into electrical outlet.
Reset Circuit Breaker /
Ground Fault Interrupter,
or replace fuse. If you
need assistance, contact a
licensed electrician.
Refill Water Tank using
procedures on Page 8 of
this manual.
Follow Removing Mineral
Build-Up procedure on
Page 10 of this manual.
See Installing Water
Treatment Cartridge on
page 9 of this manual.
Shake the unit vigorously
until pick up ball is
dislodged.
Refill Water Tank using
procedures on Page 8 of
this manual.
It is normal for steam
pressure to drop
periodically for a few
seconds. If steam stays off
for longer periods, follow
Removing Mineral Build-Up
procedure on Page 10 of
this manual.
Unplug unit for 30 seconds.
Plug back into outlet to
resume normal operation.
ENGLISH | 11