Technical Specifications; Forward/Reverse Switch - Toolland TM 81006 Mode D'emploi

TM 81006
INSERTING AND REMOVING A DRILL OR
SCREW BIT
Open the chuck.

Insert the drill or the screw bit in the

chuck.
Fasten the chuck by hand.

Fasten the chuck firmly by inserting the

chuck key in one of the holes in the side
of the chuck and turning it clockwise.
In order to remove a drill or screw bit,

you proceed in reverse order.
Before inserting or removing a drill
or screw bit always pull the plug
from the wall socket.
MOUNTING THE SIDE GRIP
Loosen the side grip

Slide the side grip over the chuck and

onto the machine.
Turn the side grip into the required

position and tighten it firmly.
MOUNTING THE DEPTH STOP
The depth stop is used to limit the maximum
drilling depth.
Loosen the side grip.

Insert the depth stop into the hole in the

side grip.
Set the depth stop to the required drilling

depth.
Tighten the side grip firmly.

SELECTING THE OPERATING MODE
Select the required operating mode before
use (drilling or hammer drilling).
For drilling in wood, metal, plastics and

soft stone and for driving screws, turn
the drill symbol on the switch to the
arrow.
For drilling in masonry, turn the hammer

and drill symbol on the switch to the
arrow.
Always wait until the motor has
come to a complete standstill
before changing the operating
mode.

FORWARD/REVERSE SWITCH

Push the forward/reverse switch to the

left to drill holes and fasten screws.
Push the forward/reverse switch to the

right loosens screws.
www.toolland.eu
Always wait until the motor has
come to a complete standstill
before changing the direction of
rotation.
ADJUSTING THE SPEED
This machine has been fitted with an
adjusting wheel for the maximum speed.
Turn the adjusting wheel as indicated on

switch to set the maximum speed.
SWITCHING ON AND OFF
To switch the machine on, press the

on/off switch. The further you press the
switch, the higher the speed of the
machine.
To switch off the machine, release the

on/off switch.
To switch the machine to continuous

mode, keep the on/off switch pressed and
at the same time press the lock-on/off
switch.
To switch off continuous mode, press the

on/off switch again.

TECHNICAL SPECIFICATIONS

Voltage
Frequency
Power
Speed (under load)
Drilling capacity
Wood
Steel
Concrete
Weight
Level of sound pressure measured according
to EN-standards:
Lpa (sound pressure)
Lwa (acoustic power)
Weighted root mean square acceleration
value according to EN 60745:
WARANTY
Refer to the enclosed warranty conditions for
the terms and conditions of warranty.
English
230V
50Hz
850W
3.000t/min
25mm
10mm
13mm
1,8kg
99,4dB(A)
k=3dB(A)
110,4dB(A)
k=3dB(A)
6,643m/s² k=1,5m/s²
9