How To Use Your Transceiver; Manual Squelch; Rotary Knob - PRESIDENT MARTIN Manuel D'utilisation

- Change the switch to position REF (reading of the SWR level). The reading on
the Meter should be as near as possible to 1. If this is not the case, readjust
your antenna to obtain a reading as close as possible to 1. (A SWR reading
between 1 and 1.8 is acceptable).
- It will be necessary to recalibrate the SWR meter after each adjustment of
the antenna.
WARNING: In order to avoid any losses and attenuations in cables used for
connection between the radio and its accessories, PRESIDENT recommends
to use a cable with a length inferior to 3 m.
Your transceiver is now ready for use.
B) HOW TO USE YOUR TRANSCEIVER
1) ON/OFF ~ VOLUME
Turn on : turn VOL knob (1) clockwise. If the function KEY BEEP is active (see
menu KEY BEEP page 30), the radio emits a beep. The radio is "on".
Display briefly shows the frequency band (see § FREQUENCY BAND SELEC-
TION page 31).
Turn Off : turn VOL knob (1) counterclockwise until radio emits click sound.
Your radio is "off".
Volume Adjustment: rotate VOL knob (1) clockwise to
Turn the same knob counterclockwise to
2) ASC (Automatic Squelch Control) ~ SQUELCH
Suppresses undesirable background noises when there is no communication.
Squelch does not affect neither sound nor transmission power, but allows a
considerable improvement in listening comfort.
a) ASC: AUTOMATIC SQUELCH CONTROL
Worldwide patent, a PRESIDENT exclusivity.
Turn the SQ knob (2) anti-clockwise into ASC position.
No repetitive manual adjustment and a permanent improvement between
the sensitivity and the listening comfort when ASC is active. This function can
be disconnected by turning the switch clockwise. In this case the squelch
adjustment becomes manual again.
b) MANUAL SQUELCH
Turn the SQ knob (2) clockwise to the exact point where all background
noise disappears. This adjustment should be done with precision as, if set
to maximum (fully clockwise), only the strongest signals will be received.
increase
the volume.
reduce the sound level.
appears on LCD.
disappears from LCD.
28
3) RF GAIN
Turn the RF GAIN knob (3) to
tion in the case of long-distance call reception. You can decrease the RF
GAIN, to avoid distortions, when the interlocutor is near. Reduce the gain
on reception in the case of a close communication with a correspondent
not equipped with a RF POWER.

4) ROTARY KNOB

Turn the ROTARY knob (4) to adjust
decrease
terclockwise to the channel.
See § UP/DN BUTTONS ON THE MICROPHONE page 30.
5) LCD
Indicates transmission
AM mode selected
FM mode selected
UK FM mode selected (only in U configuration / ENG)
VOX
VOX function activated
EMG
Emergency channel (1 or 2) is activated
Automatic Squelch Control activated
ANL ANL filter is activated
ROGER BEEP function activated
BP KEY BEEP function activated
MENU mode activated
Indicates the active channel
SCAN function activated (the dot blinks)
Indicate TX or RX power
set
the reception sensitivity. Maximum posi-
channel. Clockwise to increase, coun-