Reversing The Door - Polar Refrigeration CE202 Mode D'emploi

Installation
Note: If the unit has not been stored or moved in an upright position, let it stand
upright for approximately 12 hours before operation. If in doubt allow to stand.
1. Remove the appliance from the packaging and the protective film from all surfaces.
2. Avoid positioning the wine cooler in direct sunlight or damp areas.
3. Maintain a distance of 20cm (7 inches) between the unit and walls or other objects for ventilation.
NEVER LOCATE NEXT TO OR NEAR A HEAT SOURCE.
4. If necessary, adjust the screw legs of the wine cooler to make it level.

Reversing the Door

Depending on the location of the appliance, it may be necessary to change the direction the door of the
wine cooler opens by changing the side of the door handle.
To reverse the door handle:
1. Ensure the appliance is disconnected
from the power supply.
2. Tilt the appliance back slightly and prop
it securely. The appliance must not be
tipped back by more than 45 degrees.
3. Unscrew the door hinge screws on the
base of the door and remove the Hinge.
4. Open the door slightly and remove the
door in a downwards direction.
5. Remove the plastic screw cover from
the top of the wine cooler by levering it
off with a small screwdriver.
6. Unscrew and remove the hinge from the
top of the appliance.
7. Screw the reversed door frame Hinge to
the opposite side of the appliance and
reattach the screw cover.
8. Fit the door into place by locating the
upper Hinge first then closing the door.
9. Reattach the Bottom hinge onto the
opposite side of the door.
10. The appliance can now be lowered into
position.
CE202-CE203-CE204_ML_A5_v6_20180403.indb 5
UK
Screw cover Top hinge
Bottom hinge
2018/4/3 14:19
5