VAPamore MR-100 PRIMO Mode D'emploi Et Manuel De L'utilisateur page 9

BEDBUG - DUST MITES - ALLERGENS
GO TO VAPAMORE.COM TO SEE THE MR-100 PRIMO INSTRUCTIONAL VIDEO
The Vapamore MR-100 Primo produces steam with an output temperature between 210˚
to 220˚ degrees. Pests such as bedbugs, dust mites and other allergens along with their
eggs are killed on contact at a temperature of 180˚ degrees. Using steam is an extremely
other bacteria or viruses without leaving any harmful chemical residue behind. The tools
supplied with the Vapamore MR-100 Primo allow you to treat all areas where these pests
can hide such as bedding, sofas, furniture, pillows, carpet, cracks and crevices that are
ideal hiding places for pests.
Fig. 25
Fig.26
cloth
Fig.27
Carpet slider
Fig.28
Detail adapter with steam gun
Fig.29
Detail adapter with ectension tube
BEDDING / FURNITURE
The clothes / fabric tool with the cotton cover is ideal for
treating bedding, furniture, pillows, and carpet areas
around bed posts and base boards. Start by installing
the supplied cotton cover on the clothes - fabric /
smooth surface tool. Apply light consistent pressure and
slowly pass it along the surface (1" per second) to insure
the area being treated has a chance to come to full
temperature killing pests and their eggs. (Fig. 25)
great for treating large surface areas such as bedding,
furniture, and carpet areas. Start by installing the
head to glide over fabric or carpet. (Fig. 26 - 27)
Apply light consistent pressure and slowly pass it along
the surface (1'' per second) to ensure the area being
treated has a chance to come to full temperature killing
pests and their eggs.
The steam gun with the detal adapter can be used as a
straight jet nozzle tool or along with the 90 degree jet
nozzle attachment. These tools are great for cracks and
crevices. Make sure to concentrate the steam directly on
the area to be treated with as minimal distance as
possible, no more than 1'' away. The steam will condense
eggs if the jet tip is not directly on the surface being
treated. The 90 degree jet nozzle can be attached directly
to the steam gun or the extension tubes. (Fig. 28 - 29)