Fig. 7 - VAPamore MR-100 PRIMO Mode D'emploi Et Manuel De L'utilisateur

FILLING & OPERATION
GO TO VAPAMORE.COM TO SEE THE MR-100 PRIMO INSTRUCTIONAL VIDEO
outlet. Allow steam cleaner to cool down before removing water tank cap. Unscrew the
water tank cap (Fig. 7) by pressing the cap down and simultaneously turning counter
clockwise. Check the water level with the supplied dipstick. Use the supplied funnel
equal 1400ml /1.4 liters. (Fig. 8)

Fig. 7

Dip
stick
Fig. 8
NOTE:
Do not ov er fill
Fig. 9
Fig. 10
Green
Red
light light
Fig. 11
Always use the dipstick to check the
1400ml / 1.4 liters. If so turn the machine over and
remove water to adjust water level.
3 marks, F is full 1400ml, apox. 1 hour steam time - H is
half full 700ml, aprox. 30 min steam time - L is low
200ml, aprox. 10 min steam time.
Make sure steamer is completely cooled
the cap while the steamer is hot can cause scalding
and severe burns.
Replace the water tank cap by pressing down on the cap
and simultaneously turning it clockwise. Make sure the
cap is fully tight to prevent any steam from leaking out.
and once cooled down tighten cap further.
Plug the
The red light will illuminate when the power button is
depressed indicating the unit is heating. The green light
will illuminate indicating the unit is fully heated and
ready for use (approximately 11 minutes). The green
temperature during use. (Fig. 10)
Once the green light illuminates the
steamer is ready for use. The green and red light will
continue to use the steamer as you normaly would
Release the locking device (child - proof
device) by sliding the lock down away from the trigger.
(Fig. 11)
The dipstick has
or
(Fig. 9)