HSGM STYRO-CUT 140 Mode D'emploi page 4

Never touch the blade after the switch has been pressed down.
Do not lay the unit against any surface after using until the blade has cooled down.
Do not operate the product in unfavourable ambient conditions.
Unfavourable ambient conditions are:
• Moisture or too high air humidity,
• Dust and flammable gases, fumes or solvents,
• Strong vibrations.
Always unplug the unit when not used.
Safety instructions
Observe this safety instructions at all time!
The unauthorized conversion and/or modification of the product is inadmissible because of safety and appro-
val reasons (CE).
The connection cable is to be replaced only by the manufacturer or his servicing agent who have a special
tool available.
This appliance has a polarized plug (US-type: one blade is wider than the other). To reduce the risk of electric
shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician. Do not modify the plug in any way.
The structure of the heatcutter complies with the safety class II. Make sure that the insulation of the housing
is neither damaged nor destroyed.
Operation
1. Unscrew the binding screws.
2. Insert the cutting blade.
3. Tighten binding screws again carefully.
4. Before you plug in the tool, check the voltage which is indicated on the label.
5. When you press down the switch the cutting blade heats up. After about 6-8 secs. the suitable cutting
temperature is received.
6. The blade may be cleaned with a metal brush while it is still warm.
7. After working release the switch of the heatcutter
Do not hold the unit in "ON" position continuously to prevent abnormal high blade tem-
perature.
Allow the blade to cool down during operation. The indication "intermittent operation 1/4
min." means the following. The tool is not dimensioned for continuous operation. After 1/4
minute of heating respectively working with the tool it shall cool down for 3/4 minutes.
Technical data
Operating voltage
Power consumption
Intermittent operation
Weight
Guarantee
HSGM GmbH warrant this appliance (with exception of the blade) for a period of 1 years commencing with
the date of sale. The guarantee is given against defects in material and workmanship. It is voided by impro-
per operation, disassembly, repair or alteration by owner or unauthorized third parties.
This device fulfil the requirements of the EU-Directives
2004/108/EC „EMC-Directive"
2006/95/EC „Low Voltage Directive"
Therefore this device is marked with the CE-Mark.
Type ENGEL-CUTTER
230V~ 50-60Hz (110V~ 50-60Hz)
100W
12s ON / 48s OFF (1/4 min.)
1025 g
Type HSGM STYRO-CUT 140
230V~ 50-60Hz (110V~ 50-60Hz)
110W
12s ON / 48s OFF (1/4 min.)
1025 g