GE 21 Série Manuel D'utilisation page 24

REMOVING THE FREEZER DRAWERS
The freezer drawers can be removed, if needed, to
fit through tight areas.
Read these instructions completely and carefully.
BOTTOM DRAWER
REMOVE THE BASKET
1
A Open the bottom freezer drawer until it stops.
Pull the divider forward until the rear locating tabs
B
are out of the slots. Turn the divider slightly to the
side to release the front locating tabs and lift out.
The freezer basket rests on the metal slide brackets
C
and is held in place with swing locks.
D Turn the swing locks from horizontal to vertical
position.
Lift the front of the basket up, rotate it toward you,
E
and bring it straight up to remove.
Lift the back portion of the basket up and out
F
of the drawer.
Installation Instructions
A
24
(cont.)
REMOVE THE DRAWER FRONT FROM
2
THE SLIDES
A Remove the hex-head screw from each side
of the rail assembly.
B Tilt the drawer front toward the refrigerator
and lift out.
Rail
assembly
Screw
Set the drawer front on a non-scratching
C
surface.
D Push the rail assemblies back into the cabinet.
REMOVE THE BASE GRILLE
3
(if needed)
If, after removing the freezer drawer and
refrigerator door, the refrigerator will still not fit
through a doorway, the base grille can be
removed.
A
Remove the 2 Phillips-head screws on either
side of the base grille.
Pull the grille straight out.
B