Door Handle - GE 21 Série Manuel D'utilisation

INSTALLING THE REFRIGERATOR
REMOVE THE FRESH FOOD
6

DOOR HANDLE

(For placement in the installation location or
reversal of the handles – on some models)
Stainless steel (on some models):
REMOVING THE DOOR
A
HANDLE: Loosen the
set screws with the
3/32 Allen wrench
and remove the
handle. NOTE: For
Double Door models,
follow the same
procedure on the
opposite door.
Plastic handle (on
some models):
A REMOVING THE DOOR HANDLE: Depress the tab on
the underside of the handle and slide the handle up
and off of the mounting fasteners.
REVERSING THE
DOOR HANDLE
(on some models):
• Remove the
handle mounting
fasteners with a
1/4 Allen
wrench and
transfer the
handle mounting
fasteners to the
right side.
• Remove the logo
badge.
• Remove and
transfer the plug button to the left
side of the fresh food door. NOTE: Use a flat plastic
edge to prevent damaging the door. Remove any
adhesive on the door with a mild detergent. Remove
the paper covering on the adhesive backing on the
logo badge prior to carefully attaching the badge to
the door.
Installation Instructions
Badge
A
B
Mounting
Fasteners
(appearance may vary)
B
Badge
A
Mounting
Fasteners
(appearance may vary)
(cont.)
REMOVE THE TOP AND BOTTOM
7
FREEZER DRAWER HANDLES
Stainless steel and plastic handles:
Loosen the set screws located on the underside of
A
the handle with the 1/8 Allen wrench and remove
the handle.
NOTE: If the handle mounting fasteners need to be
tightened or removed, use a 1/4 Allen wrench.
A
A
20