Before Initial Use; Inserting / Removing The Battery; Charging Up The Battery - MAXXMEE 09524 Mode D'emploi

EN

BEFORE INITIAL USE

Before the device can be used,
• remove the transport protection
between the device and impact
guard (5).
• insert the battery (see the "Inserting /
Removing the Battery" chapter).
• charge up the battery (see the
"Charging Up the Battery" chapter).
INSERTING / REMOVING
THE BATTERY
Please Note!
■
The device must not be connected
to the mains power while the battery
pack is being removed / inserted.
■
You should never open the battery
pack!
To insert the battery into the robot vacu-
um cleaner, proceed as follows:
1. Take the cover (4) off the device.
2. Unscrew the screw on the battery
compartment and take off the cover.
3. Plug together the cable of the battery
and the cable in the battery compart-
ment.
4. Tuck away the cable and battery in the
battery compartment, place the cover
back on and tighten the screw.
5. Place the cover on the device. When
you do this, make sure that the lock-
ing lugs sit in the recesses which are
provided for them. The cover must be
heard to engage in place.
To remove the battery from the robot
vacuum cleaner, open the battery com-
partment in the same way and release the
plug connection between the cables by
pressing the locking lug.
Store the battery in an ambient temper-
ature of 0 – 40°C or dispose of it in an
environmentally friendly way.
16
09524_Inlay_DE-EN-FR-NL_A5_V1.1.indb 16 09524_Inlay_DE-EN-FR-NL_A5_V1.1.indb 16
CHARGING UP THE
BATTERY
Please Note!
■
Only connect the charger to a plug
socket that is properly installed and
matches its technical data. The plug
socket must be readily accessible after
connection so that the connection to
the mains can quickly be isolated.
■
Only use suitable extension cables
whose technical data is the same as
that of the charger.
■
The device must be switched off dur-
ing the charging process.
■
Pull the charger out of the plug socket
if an error occurs during charging or
before a thunderstorm.
■
Only ever charge up the battery
using the charger that is supplied
with the device (Model No.: DZ006E-
HL090050V). Do not use the charger
that is supplied to charge up any
other devices.
It is essential that you charge up the
battery fully before you fi rst use the
device in order to achieve the maxi-
mum charging capacity.
If the operating lamp (1) fl ashes red,
the battery is weak and needs to be
charged. The device automatically
switches off after a few minutes.
 
If the battery is fully discharged
during use, it must be fully charged
up again before it is next used.
First plug the barrel connector of the
charger into the connecting socket (12) of
the device and then connect the charg-
er to a plug socket. The charge control
lamp (3) lights up red during charging. .
When the charge control lamp lights up
green, the battery is fully charged.
03.09.2020 14:59:18 03.09.2020 14:59:18