Switch Off The Appliance - Hotpoint Ariston HB 06 EU Mode D'emploi

that they do not play
with the appliance.
18. Do not use outdoors.
19. Save these instructions.
20. Take care of potential
injury from misuse.
21. Care shall be taken
when
sharp cutting blades,
emptying the bowl and
during cleaning.
22. Do not allow children to
use the blender without
supervision.

23. Switch off the appliance

and disconnect from
supply before changing
accessories
approaching parts that
move in use.
USING THE BLENDER (A)
Attention: Blades are very sharp, handle with
care. Ensure that the hand-held blender is
unplugged from the power outlet before assembling
or removing the attachments.
Attention: Max operation time without load is
15 seconds.
Attention: Max operation time with load cannot
exceed 1 minute, and a 3 minutes rest time must
be respected after two consecutive cycles.
1. To assemble the detachable shaft with the
motor unit, turn the shaft anti-clockwise direction
until tightened. To disassemble, just turn in the
adverse direction.
handling
2. Simply plug the hand-held blender to power
outlet.
3. Lower the blender into the food. Then press
and hold the START button to operate. At the
same time you can select desired speed setting
by dialing the speed control dial and the speed
will increase gradually when you dial the speed
control dial from right to left.
4. To start operating by pressing and hold the
TURBO button is possible as well:, the appliance
will operate at the highest speed all the time.
Note: When operating by the TURBO button,
the
the speed will not change even if you operate
the speed control dial.
5. Stop the blender by releasing the START or the
TURBO button.
Blades and discs are very sharp: handle with
care.
USING
ATTACHMENT (ONLY ON SOME
MODELS) (B)
Caution: Maximum operation duration per time
cannot exceed 1 minute, and a 3 minutes rest
time must be observed after two consecutive cycles.
or
1. Place the chopper bowl on a clean, level surface.
2. Assemble the stainless chopping blade into the
chopper bowl, as shown in Fig.1.
3. Place food into the chopper bowl.
Note: Remove the bone of the meat, cut small
pieces, then place the meat into the bowl.
Note: The max quantity of meat can't exceed
200g.
4. Assembly the lid onto the chopper bowl
5. Insert the motor unit into the hole of the chopper
lid, and turn in clockwise direction to lock.
6. Plug the appliance to the power outlet. Then
press and hold the START button to operate.
At the same time you can select desired speed
setting by dialing the speed control dial and
the speed will increase gradually when you
dial the speed control dial from right to left.
To start operating by pressing and hold the
TURBO button is possible as well:, the appliance
will operate at the highest speed all the time.
THE CHOPPER
it en
11