Using Your Ice Maker - H.Koenig KUBE KB15 Manuel D'utilisation

2. Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not under
any circumstances, cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified
electrician.
3. This appliance requires a standard 220-240volt, 50Hz electrical outlet with three-prong
ground.
CLEANING AND MAINTAINING YOUR ICE MAKER
Before using your ice maker, it is strongly recommended to clean it thoroughly.
1. Take out the ice basket.
2. Clean the interior with diluted detergent, warm water and a soft cloth.
3. Then use the water to rinse the inside parts, and drain out the water by unplugging the drain
cap on the side.
4. The outside of the ice maker should be cleaned regularly with a mild detergent solution and
warm water.
5. Dry the interior and exterior with a soft cloth.
6. When the machine is not in use for a long time, open water drained cap to drain water
completely from water reservoir.

USING YOUR ICE MAKER

START TO MAKE THE ICE-CUBE
1. Open the cover, remove the ice basket and pour water into water reservoir.
Keep water level below the level mark.
2. Press "ON/OFF" button on the control panel to turn on the unit to begin the ice making cycle.
3. Select the size of the ice cube by pressing the "Select" button. Three sizes: SMALL, MEDIUM
or LARGE can be selected:
SMALL MEDIUM
If the room temperature is lower than 60
ice sign button in order to avoid ice sticking together.
4. The ice making cycle lasts 6 to 15 minutes, depending on the size of the ice cube selection
and the ambient temperature. In the extreme hot room temperature, ice-making time maybe
vary a lot.
5. While the icemaker is on, verify water level periodically. If water pump can't inject water, the
ice maker will stop automatically, and the "
water up to the level mark and press "ON/OFF" button two times again to turn on the unit
again. Allow the refrigerant liquid inside the compressor at least 3 minutes to settle before
restarting.
LARGE
, it is recommended to select the small or medium
℉
" symbol will flash in LCD display window. Fill