Istruction To Display The Parameters - Remote Panel Version; Checks, Regulations And Adjustments; Starting - Zanotti ZN Série Notice De Mode D'emploi Et D'entretien

8.4 I struction to display the param eters – R em ote P anel version
By pressing and releasing the
"Set" label will be displayed. Through the
Setting up the Setpoint:
To display the Setpoint value press the
The Setpoint value is displayed.
To change the Setpoint value press within 15 sec, the
wait 15 sec before quitting.
Displaying the probes:
When the labels Pb1 or Pb2 appear, when the
probe is displayed.
Pb1 displays the cell temperature
Pb2 displays the end of de-frosting temperature.
Starting the manual de-frosting cycle:
To start a de-frosting cycle, press the
Cell light activation:
The cell light is switched on when the key
ON/OFF function:
When the ON/OFF key is pressed for at least 5 sec. the equipment is set to stand-by and displays OFF.
this configuration the unit is not active. To set the equipment to ON press the key again.
WARNING
The unit is pow ered even w hen OFF continues to be displayed on the control unit.
9 Checks, regulations and adjustm ents
9.1

Starting

key you can access the menu. If there are no alarms in progress the
and
- SEt: setting folder
- ALr: alarm directory
- Pb1: environment probe value folder
- Pb2: end of de-frosting probe value folder
Before turning the unit on, check that:
- locking screws are tight
- electrical connections have been carried out correctly.
In the event that the unit has been opened:
- no tools were left inside
- assembly is correct
- there are no gas leaks
- front cover is secured correctly
Before starting the unit act as follows:
Connect the unit to the mains. The luminous switch lights up
-
If the unit has a preheating cycle, leave it in this condition for at least 3 hours.
-
If the unit has a voltage monitor, leave it in this condition for at least 7 minutes to
-
have the counting phase carried out
Switch on the control by pressing key 0/1.
-
Set the required cold room temperature.
-
keys the menu folders can be scrolled:
key when the "Set" label is displayed, then press "Set" again.
and keys. To confirm the change press
key is pressed the measured values of the associated
key for at least five seconds.
is pressed.
and
In
27