Installation - Zanotti ZN Série Notice De Mode D'emploi Et D'entretien

6.5 I nstallation
Straddle version:
Before mounting the unit prepare the cuts in the cold room wall as shown in the picture.
Fix the unit in place with the appropriate screws. Position the unit on the cold room, connect the evaporator
drain tray spigot and the hole prepared in the cold room wall using the supplied pipe with pre-inserted
heater (for low temperature units only). Fill the hole in the wall with insulating material, polyurethane or
silicone, and mount the hole cover.
ZN0 Max. 100
ZN 0-1 Max 100
Mod.
ZN0
ZN1
ZN2
ZN3
ZN2 P
ZN3 P
ATTENTI ON
Check that the unit and its devices have suffered no dam ages during transport. P ay
special attention to the com ponents
secured to the electric panel door and to the refrigerating circuit pipes. M ount the unit
as show n in the draw ings; m ak e sure that the electric connections are carried out
properly.
ZN1-2-3 Max. 120
ZN 2-3 Max 120
B C
312 220
316 288
380 595
455 635
295 642
320 634
E
D. 22
D E
90 45
83 45
90 55
75 45
75 45
75 45
C
=
E
=
G
F
F G
20 -
-22 -
297,5 297,5
217,5 416,5
320 -
317 -
22