Istruction To Display The Parameters - On-Board Version - Zanotti ZN Série Notice De Mode D'emploi Et D'entretien

ON-BOARD VERSION
Compressor Led
Fixed onCompressor enabled
Flashing Anti-short cycle delay enabled
Defrost Led (De-frosting)
Fixed on: Defrost enabled
Flashing: Drip time in progress
Fan Led
Fixed on: Fans enabled
Flashing Fans delay after defrost in
progress
Led Alarm
Fixed on: An alarm is occurring
8.3 I struction to display the param eters – On Board version
HOW TO SEE THE SET
Push and immediately release the SET key: the display will show the Set point value;
Push and immediately release the SET key or wait for 5 seconds to display the probe value again
HOW TO CHANGE THE SET POINT
Push the SET key for more than 2 seconds to change the Set point value;
The value of the set point will be displayed and the "°C" or "°F" LED starts blinking;
To change the Set value push the o or n arrows within 10s.
To memorise the new set point value push the SET key again or wait 10s.
HOW TO START A MANUAL DEFROST
Push the DEF key for more than 2 seconds and a manual defrost will start.
COLDROOM LIGHT:
The coldroom light is switched on when the key (LIGHT) is pressed.
ON/OFF function:
When the ON/OFF key is pressed the equipment is set to stand-by and displays OFF.
the unit is not active. To set the equipment to ON press the key again.
W ARN I NG
The unit is pow ered even w hen OFF continues to be displayed on the control unit.
POINT:
REMOTE PANEL VERSION
Compressor Led
Fixed on: active compressor
1
Flashing: delay, blocked protection or
activation
Defrost Led (De-frosting)
2 Fixed on: active de-frosting
Flashing: Mmanual activation or by I.D.
Fan Led
3
Fixed on: active fans
Reduced Set Led/ Economy
ON with fixed light : Energy saving ON
4
Flashing light: Reduced Set ON
Alarm Led
Fixed on: alarm
5
Flashing: muted alarm
Display Led in F
6
ON with fixed light : Setting in F
AUX Led
7
ON with fixed light : Cold room light ON
Display Led in °C
8
ON with fixed light : Setting in °C
In this configuration
26