Maintenance Instructions; Procedures In The Event Of Faults - KNAUS Calira Bord Control 2005 Mode D'emploi

Maintenance instructions

" (
' (
Clean the device with a dry, lint-free cloth.

Procedures in the event of faults

The device is maintenance-free. However, if any faults do occur, please
proceed according to the following table:
Fault Action
The voltage of Batteries Check on the line to the batteries and fuses
1 or 2 is not indicated.
The level of one of the Check on the tank cable and the contact sensors of
water tanks is not the tank.
shown.
Charging is not Check on the lines to the PS
indicated
One or several of the Check on the switches and fuses in question.
circuits are not being
supplied.
The user circuits , the If the red energised indicator illuminates with the
WC circuit and the main switch on, the supply battery must be charged.
pump circuit are not By pressing the EMERGENCY ON illuminated
being supplied. button, the consumer circuits can be switched on for
approx. 2 minutes
Complete malfunction. Check on the jacks as to a secure fit at the PS and
Bord Control. Check on the lines to the batteries
and the fuses in the lines to the +poles of the
batteries.
None of the faults Please contact the manufacturer:
described here seems to Trautmann GmbH & Co. KG
apply. But the device CALIRA-Apparatebau
still does not work. Lerchenfeldstrasse 9
D-87600 Kaufbeuren
Internet: www.calira.de
e-mail: info@calira.de
34
Lerchenfeldstr. 9 87600 Kaufbeuren Phone: +49 (0)8341 9764-0 Fax: +49 (0)8341 67806
'