SEVERIN KM-3887 Mode D'emploi page 13

Functions and operation settings
Shredding insert Function
Shredder, fine (A) fine grating/shredding
(e.g. cabbage, carrots,
celery)
Shredder, coarse coarse
(B) grating/shredding
(e.g. kohlrabi, salsifies)
Slicer, thick (C) cutting thicker slices
(e.g. cucumber, carrots,
potatoes)
Slicer, thin (D) cutting thinner slices e.g.
vegetable slices, potato
crisps)
Potato grater (E) grating potatoes (e.g. for
potato pancakes)
Cutter for French cutting French fries
fries (F)
Note: to facilitate choosing the appropriate
attachment, the corresponding letter
markings on the cutting and grating inserts
are also included in the table.
E. Citrus juicer
- Place the safety lid on the blender
mounting and lock it by turning anti-
clockwise.
- Fit the bowl.
- Place the pulp sieve on the bowl and
lock it by turning the sieve anti-
clockwise.
- Fit the juicer dome to the drive shaft.
- The system allows up to 1 litre of juice
to be extracted from the fruit (washed
and cut in half) before it is necessary to
empty the bowl.
- When processing larger fruit quantities,
the filter must be emptied from time to
time.
Operation setting
- Set the speed control to Min.
F. Juice extractor
- Place the safety lid on the blender
mounting and lock it by turning anti-
clockwise.
- Attach the bowl and fit the 2-part filter
basket to the drive shaft.
Speed - Place the juicer lid on the bowl and turn
it anti-clockwise to lock; the arrow-
4 - 6
mark on the lid must be aligned with
the corresponding dot on the housing.
- For safety reasons, use the appropriate
4 - 6
pestle at all times when feeding the
ingredients down the food chute.
During operation, the pestle should
4 - 6
remain inserted.
- While the appliance is running, feed the
prepared pieces of fruit into the chute,
4 - 6
using the pestle to push it lightly down.
- Caution: too much pressure may result
in damage to the motor or the insert.
4 - 6
- When processing larger quantities of
fruit or vegetables, the filter basket and
4 - 6
the juice container must be emptied
from time to time.
Operation setting
- Set the speed control to Max.
G. Blender
- Remove the safety lid from the blender
mounting by turning it clockwise to
unlock.
- Fit the bowl.
- Place the lid on the bowl and turn it
anti-clockwise to lock.
- Place the blender jug on its mounting
and turn it anti-clockwise to lock.
- Put in the ingredients, then fit the
blender lid and lock it by turning anti-
clockwise.
- To add ingredients during operation,
remove the small stopper in the centre
of the blender lid; turn clockwise to
unlock it.
- After processing, switch off the
appliance and remove the blender jar
by turning it clockwise and lifting it off.
- Caution:
Do not let the blender unit run dry (i.e.
without any contents).
- Maximum fill amount:
1 litre of liquid, or
300g of fruit, or
13