Memphis AJ140-S Manuel D'utilisation page 13

USING THE POWER ON/OFF BUTTON
Pressing the Power on/off button(10) once to turns the unit on.
Pressing the Power on/off button(10) again will tum the unit off.
If you find that none of the other buttons appear to work, check to
make sure that the Power on/off button(10) is turned on.
USING THE FLAME CONTROL BUTTON
Pressing the flame control button (11) to turn on the flame effect.
To press the flame control button (11) to adjust the flame brightness,
there are 3 levels of flame brightness, L3-L2-L 1-L3.
USING THE THERMOSTAT CONTROL BUTTON
Pressing the thermostat control button(12) to tum on the heating
function.
Pressing the thermostat control button(12) again to tum on the heating
function. Continue to press the thermostat button(12) to cycle through
the different heat settings, 17C-18.C-19C-..... -26C-27"C-ON- OFF.
To display the temperature setting in either Fahrenheit or Celsius,
press the thermostat button (12) of control panel once, then press and
hold the power on/off button (11) of the control panel for 5 seconds.
The display will switch between Fahrenheit or Celsius.
USING THE TIMER CONTROL BUTTON
Pressing the timer control button (13) will set the timer. This interval
period is shown in the display (8) on the control panel on the side of
the electric fireplace. There are total 8 levels timer settings, from 0.5hr
- 1 hr - 2hr - 3hr - 4hr - 5hr - 6hr - OFF.
USING THE WEEK TIMER CONTROL BUTTON
Note:
Besides a regular timer function, this unit also equipped with week
timer function, to setup the time when to turn on and off the heater
with desired temperature, one group each day and max. 7 days/
group available. if stop pressing any of those buttons for more than 5
seconds, will quite the week timer function and confirm the previous
setting.
13