Memphis AJ140-S Manuel D'utilisation page 11

Put the plugs [ 4 ] in the holes, set up the wall mounting bracket [ 2 ]
as in the picture below, and fix it to the wall by screwing the 3 screws
clockwise into the holes.
Hang the electric wall heater on the wall mounting bracket.
Insert the power plug [4] into an earthed power outlet.
Note: Please ensure that the power plug is still accessible after
installation of the electric fireplace.
Note: Ensure that the electric fireplace is correctly installed. In case of
any doubt, please contact a professional.
Your electric fireplace is now ready for operation.
Operation
The voltage of the power source must comply with the specifications
on the ratings plate of the heater. Devices marked with 230 V can
also be operated at 220 V. Before use it is imperative to ensure that
the installation location corresponds to the requirements of the safety
instructions.
Note: When the heater is turned on for the first time, a slight,
harmless odour can develop. This odour develops due to the heating
up of the inner heating elements. Provide sufficient ventilation.
Note: Your heater is fitted with a safety device that will switch off
the heater in case of overheating. If the heater stops working, tum
the heater off and inspect inlet and outlet for blockages. Unplug the
appliance and wait at least 1 O minutes for the protection system to
reset before attempting to restart the heater. If the safety device still
11