Checking The Wiring; Installing The Audio Connectors; Installing The Remote Control - Parrot MKi9200 Guide D'utilisation De Rapide

• Refer to your car stereo's wiring diagram.
• The red wire of the kit's cable must correspond to the
constant +12V supply, the orange wire to the ignition +12V
and the black wire to ground.
• Check that the orange wire is not connected to the
constant +12V supply, as you could run down the vehicle's
battery, preventing your hands-free kit from operating
correctly.
On some vehicles, there is no ignition +12V on the
vehicle's connectors. You must therefore connect
the orange power supply wire to the fuse box or
another ignition power source.

Checking the wiring

To perform the installation check, turn the ignition on, wait
a few seconds then turn it off once the Parrot MKi9200 is
installed: the message "Good bye!" must be displayed.
If it is not the case, it is necessary to inverse the positions of
the red and orange wires. Indeed, the red wire of the power
cable must be connected to the permanent 12V, the orange
wire to the 12V ignition and the black wire to the ground.
This can be done simply by reversing both fuse holders
located on the Parrot wiring.

Installing the audio connectors

• Connect the music cable to the electronic box and
place the USB / iPod / Jack connectors into the glove
box, the central console or the parcel tray depending on
the configuration of your dashboard. Make sure that the
cable is accessible and not pinched.
• Use the provided protection cap to protect the connectors.

Installing the remote control

► Refer to the diagrams p.9/10.
• Choose the place for the remote control inside your
vehicle. We would advise you to fit it in the center of the
dashboard or close to the steering wheel.
• If you want to place the remote control on the steering
wheel, make sure it is securely attached, so that it does
not move when you are driving. Do not install the
remote control on the outside of the steering wheel and
ensure it does not get in the way when driving.
• If you want to place the remote control on the dashboard,
stick the double-sided tape located on the flat side of the
bracket to fix it against the dashboard. You can then insert
the remote onto the bracket.
15