General Controls - Numark TTX USB Guide D'utilisation Simplifié

1. Power Button: Turns on the turntable when pressed. It illuminates blue when the turntable is
switched on.
2. Start/Stop Buttons: Start and stop the turntable motor. Both buttons have the same function.
3. Platter: This turntable has a special edge design that has been optimized for "dragged" platter slow
downs. The pattern will appear to stand still when the Pitch Range is set to 0% and the Target Light
is being used.
4. Forward/Reverse Toggle: Switches the motor direction between forward and reverse.
5. Start Time Adjuster: Rotate to increase or decrease the startup time of the platter.
6. Braking Time Adjuster: Rotate to increase or decrease the stopping time of the platter.
7. Strobe Target Light and Power Jack: This aluminum light can be rotated depending on the head
shell position and the amount of light required on the vinyl record surface. The light strobes against
the platter edge making the pattern appear to stand still when the Pitch Range is at 0%.
8. Pitch Fader: This slide control allows the pitch of the playback to be changed. In the center position
the pitch is at 0%
9. Key Lock: This button locks the key of the music at the relative position of the Pitch Fader. This
processing effect is only available when the LINE output is used.
10. Quartz Button: This button locks the pitch at 0% (regardless of pitch fader position) using Quartz
Motor Control when engaged.
11. Torque Adjustment: Lightly press buttons 9 and 10 simultaneously to adjust the torque settings of
the platter. There are three settings for torque. "L" is low, "M" is medium, and "H" is high.
12. 33 and 45 RPM Buttons: These buttons control the RPM of the turntable platter. When both of the
33 and 45 RPM buttons are pressed simultaneously, the 78 RPM mode will engage.

General Controls

8