Hitachi С 12LDH Mode D'emploi page 13

4. Stopper for precision cutting ... (Stopper and holder are optional accessory)
Stopper
(optional accessory)
Workpiece
Holder
(optional accessory)
Height adjustment bolt 6mm (optional accessory)
6mm wing bolt
(optional accessory)
Fig. 10
5. Confirmation for use of sub fence (A)
WARNING:
In the case of right bevel cutting, turn the sub fence (A) clockwise. Unless it is turned
clockwise, the main body or saw blade may contact the sub fence (A), resulting in an
injury.
Left bevel angle cutting
Direct angle cutting
Turn
Fence (A)
Fig. 11
6. Confirmation for use of sub fence (B)
WARNING:
In the case of left bevel cutting, turn the sub fence (B) counterclockwise. Unless it is
turned counterclockwise, the main body or saw blade may contact the sub fence (B),
resulting in an injury.
Turn Right bevel angle cutting
Left bevel angle
Direct angle cutting
cutting
Sub fence (B)
Fig. 12
7. Confirmation for use of sub fence (C)
WARNING:
In the case of left bevel angle cutting, remove the sub fence (C). If the sub fence (C) is not
removed, the sub fence (C) will contact the main unit or saw blade and result in injury.
Sub fence (C)
Fence (B)
Fig. 13
The stopper facilitates continuous precision cutting in lengths of
11" to 17-3/4" (280mm to 450mm).
To install the stopper, attach it to the holder with the 6mm wing
bolt as shown in Fig. 10.
6mm wing nut (optional accessory)
This power tool is equipped with a sub fence (A).
Right bevel
angle cutting
In the case of direct angle cutting and left bevel angle cutting, use
the sub fence (A). Then, you can realize stable cutting of the material
with a wide back face.
In the case of right bevel cutting, raise the sub fence (A) up as
illustrated in Fig. 11 and then turn it clockwise.
Sub Fence (A)
This power tool is equipped with a sub fence (B). In the case of
direct angle cutting and right bevel angle cutting, use the sub fence
(B). Then, you can realize stable cutting of the material with a wide
back face. In the case of left bevel cutting, raise the sub fence (B)
up as illustrated in Fig.12 and turn it counterclockwise.
Fence (B)
This power tool is equipped with a sub fence (C).
In the case of direct angle cutting and right bevel angle cutting, use
the sub fence (C).
Then, you can realize stable cutting of the material with a wide
back face.
English
13