Connecting The Input/Output Terminals - Pioneer DJM-250-K Mode D'emploi

Connecting the input/output terminals

! When creating a DVS (Digital Vinyl System) combining a computer, audio interface, etc., be careful in connecting the audio interface to this unit's
input terminals and in the settings of the input selector switches.
Also refer to the operating instructions of the DJ software and audio interface.
Rear panel, front panel
Audio input
section
Rear panel
ON OFF
To power outlet
AC adapter
(included)
Audio output
section
Front panel
Headphones
Headphones
cord
1 To use the fader start function, connect a control cord (page 11).
The fader start function can only be used when connected to a Pioneer DJ player.
 Cord hook
Loosen the cord hook's screw and pinch the AC adapters'
power cord under the hook.
Cord hook
! Place the cord hook out of reach of children. If a child should
swallow it, contact a physician immediately.
6
En
Audio cable
R L
R L
AUDIO
OUT
CONTROL
USB
CH-2 CH-1
SIGNAL
CD CD
PHONO / LINE PHONO / LINE
GND L
L L
L
CONTROL R CONTROL
LINE PHONO LINE PHONO
R
R R
R L R L
DC IN
R L
MASTER 2
Powered speaker, component,
To audio input terminals
Audio cable
Audio cable
R
R L
DC IN
MASTER 2
AC adapter' s power cord
Example:
CDJ-350
DJ player
Control cord 1
Microphone cable
AUX
3 2
L
MIC
L L
1
R R
R
1GND
Audio cable
3 COLD
2 HOT
MASTER 1
Audio cable
amplifier, etc.
INPUT INPUT
1 1
2 2
EQ 3 EQ 3
POWER 4 POWER 4
Audio cable
Analog player
To ground wire To audio output
terminals terminals
Ground wire
Audio cable
Microphone
To microphone
Portable audio
device
To audio output
terminals
Computer
To audio output
terminals
synthesizer
To audio output
terminals