Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
CAUTION: To prevent accidents, make
sure to turn the switch off and
disconnect the plug from the
receptacle.
NOTE:
When using tools such as bull points,
cutters, etc., make sure to use the genuine
parts designated by our company.
1. Installing Tools
(1) Clean, then smear the tool shank with the
grease (Optional accessory).
(2) Pull the tool holder in the direction of
arrow A and rotate it in the direction of
arrow B (counterclockwise). Fully insert
the tool shank into the hexagonal hole of
the front cover. (Fig. 2)
(3) Return the tool holder to its original
position, pull the tool to make sure it is
locked completely. (Fig. 3)
2. Move the side handle
The side handle can be fixed at any
desired position; 360 degrees, and can
also be fixed at any position in the back-
and-forth direction.
(1) Loosen the handle by turning the grip in
the direction of A as shown in Fig. 4.
(2) Adjust it to a position where vertical (up-
and-down) operation can be facilitated as
illustrated in Fig. 5, Fig. 6, and Fig. 7.
(3) Turn the grip in the direction of B and fix
the handle.
10
ASSEMBLY
Tool Shank
Front Cap
Tool Holder
Fig. 2
Fig. 3
Grip
A
B
Fig. 4
Fig. 6
A
Fig. 5
Fig. 7
Publicité
Table des Matières
