Evolite infinium 25 000 RGB FB4 Mode D'emploi page 13

 Installation
o Rigging
The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight for 1 hour without any
harming deformation.
IMPORTANT!OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including calculating working load limits, installation material
being used, and periodic safety inspection of all installation material and the projector. If you lack these qualifications, do not attempt
the installation yourself, but instead use a professional structural rigger. Improper installation can result in bodily injury and or damage
to property. The projector had to be installed out of the reach of people
Always secure your fixture with a safety cable !
NO. Name
1 Laser aperture
2 DB25 output
Function knob
3
FB4 control hardware
4
5 ILDA in & out
3-Pin Interlock
6
7 DMX in & out
Power ON/OFF
8
9 Safety failure switch
Key switch
10
11 Power in
Infinium 25 000 RGB FB4 User Manual Ver. 1.00
Laser output, do not look directly into this aperture
Output signal of FB4. Can link to another laser and have same graphics.
For X Y moving, invert & size; R, G, B brightness adjustment
FB4 screen control board, support Pangolin Quickshow Software
ILDA interface for laser control software
Laser output is available only when the interlock is connected.
It could be used to connect a laser emergency switch.
DMX to control FB4 programs.
Turn this switch ON to have one beam protective control. Turn OFF to
allow one beam output. (Be caution when you turn it off.)
Turn the key switch ON to allow laser output.
AC100~240V power input socket.
Function
Page 13