Proper Use; Before Starting The Equipment - EINHELL MK 2100 E Instructions D'origine

3. Proper use

The air-conditioning system is only designed
to air-condition dry rooms. The room volume
depends on the local conditions. Large window
areas, additional heat sources (PC, television,
people, etc.), poor wall insulation, etc. serve to
reduce this room volume.
The equipment is to be used only for its
prescribed purpose. Any other use is deemed to
be a case of misuse. The user / operator and not
the manufacturer will be liable for any damage or
injuries of any kind caused as a result of this.
Please note that our equipment has not been de-
signed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Before starting the equipment

•
Before you connect the equipment to the
mains supply make sure that the data on the
rating plate are identical to the mains data.
•
Always place the portable device on a firm,
horizontal footing.
•
The machine must always be in an upright
position.
•
Never tilt the device by more than 45°!
•
Whenever the device has been transported
(inclined positions), leave for at least one
hour before connecting to a socket outlet.
•
In the cooling function the warm exhaust air
must be transferred outside by the exhaust air
hose. An opening in the wall or window must
therefore be provided.
•
Please note that the minimum distance bet-
ween the equipment and the wall to the side
50 cm and rear must be 50 cm. The minimum
distance to other objects at the front must be
2 m.
4.1 Installing the activated charcoal filter
(Fig. 4)
1. Take out the filter frame
2. Remove the filter fastener from the filter frame
3. Take the carbon filter out of the bag
4. Place the carbon filter in the filter frame
5. Fasten the filter with the filter fastener
6. Slide in the filter frame
GB
4.2. Installing the exhaust air hose (Fig. 5)
Use only the supplied exhaust air hose. The
length of the exhaust air hose can be varied from
between 500 mm to 1500 mm. For the most
effective cooling the hose should be as short as
possible. Avoid kinks are excessive bends in the
hose so that the exhaust air can be transferred
out without hindrance. If you ignore this advice,
the device as a whole may overheat and shut
down. This could result in damage to the device.
Warning!
The length of the exhaust air hose is matched
to the technical specifications of the device.
Never extend the hose as this could lead to
malfunctions or faults on the device.
Under certain circumstances a partial vacuum
may develop in the room, which will lead to a
reduction in the cooling performance of the
device. To prevent this from happening you must
ensure that there is a supply of air to the room
(leave the door to the room slightly open).
Fitting the exhaust air hose through an open
window (Fig. 6)
Secure the exhaust air hose to the connection

opening for the exhaust air hose by turning it
clockwise.
Use the exhaust air adapter for the window

and the extendible window adapter. Fasten
the air adapter for the window to the exhaust
air hose by turning it clockwise. Open the
window slightly and clamp the window
adapter in the gap. Secure the window so
that the window adapter is kept firmly in
place. Insert the exhaust air adapter for
the window in the opening provided in the
window adapter.
Accessory:
Hot Air Stop
Note: Take appropriate precautions to prevent
unauthorized entry through the window.
Fitting the exhaust air hose through the wall
We recommend that you use a suitable telescopic
duct with automatic shutter and wall connection
(available at your DIY store) to which you can
connect the hose without using the exhaust air
adapter for the window.
- 21 -
Art.-Nr.: 23.651.50