Pallmann GECKO STAR 2.0 Traduction Du Mode D'emploi Original page 30

7.2 Sanding technique (N)
Caution!
The GECKO STAR 2.0 operates at a high sanding speed!
If you stay in one place for too long then this can cause dark burn marks on the floor.
So, make sure that the GECKO STAR 2.0 is constantly moving when sanding!
In order to achieve optimum results when sanding the edge of floors the machine
must be moved over the floor with a backwards and forwards motion.
The design of the sanding disc and the sliding wall protection enable
an effective sanding all the way up to the wall.
7.3 Switching off the GECKO STAR 2.0 (M)
Steps:
1. To switch off tip the machine somewhat rearwards so that the sanding attachment
is lifted off the floor.
2. Switch the machine off with the switch.
3. Unplug the mains plug.
4. Dispose of the sanding dust in the dust bag immediately in a fireproof,
non-combustible container. Seal the container with a fireproof, non-combustible
cover and store it in an outdoor location.
Note!
It is normally necessary to carry out several sanding processes in order to achieve a perfect
finish. Detailed information on the sanding processes can be found in the brochure:
Sanding parquet flooring and floorboards with the FRANK parquet sanding machine COBRA
and the FRANK parquet edge sander GECKO STAR 2.0
8 Replacing the sanding attachment (O)
Note!
The GECKO STAR 2.0 can be reconfigured by replacing the short sanding attachment
with the long sanding attachment.
Caution!
Unintentional activation of the machine may present danger. The machine must
be switched off and the mains connector unplugged to change the sanding attachment.
Steps:
1. Switch the machine off.
2. Unplug the mains plug.
3. Unscrew the screws (1 = TX30) completely.
4. Remove the sanding attachment (3).
At the same time unhook the V-belt from the V-belt drive pulley.
5. Fit the other sanding attachment in the same manner;
and fit its V-belt onto the V-belt drive pulley with slight tension.
6. Screw the screws in loosely at first. Do not tighten the screws.
7. Turn the knurled nut (4) until the v-belt is tighten, than re-tighten the bolts.
Seite 30 Gecko Star 2.0 12/2016