Table des Matières
Publicité
Always remove the power supply plug from the socket before carrying out any work
on the machine. The cool air openings in the motor casing must always be kept
clean and unobstructed to ensure air circulation. With the exception of carbon brush
replacement (see below), all maintenance and repair work which requires the motor
casing to be opened may only be carried out by an authorized service center. (Please
refer to warranty on page 3.) Keep unit clean and dry. Wipe down and clean after
each use. Do not submerge in water, or get wet. For best results always start with
clean dry pads. See page 7 for pad cleaning directions.
CARBON BRUSH REPLACEMENT
After extended use, the motor is designed to shut down
indicating the motors carbon brushes require replacement
(2 are included with product). To replace, be sure polisher is
disconnected from the power source, then follow the steps
below.
STEP 1
Remove screw from both motor brush covers.
STEP 2
Locate both carbon brushes on each side.
STEP 3
Detach power clip from polisher. Remove old carbon brush.
Remove any additional broken pieces.
STEP 4
While holding spring back, insert new carbon brush into
polisher. Secure brush with spring.
STEP 5
Attach power clip of new brush to the polisher.
Repeat Steps 3 - 5 for other brush.
STEP 6
Once replacement of both brushes is complete, replace
motor brush covers.
6
MAINTENANCE & CARE
1
2
3
4
5
6
Dual Action Polisher PRO User's Guide
Publicité
Table des Matières
