Table des Matières
Publicité
4
SETTING THE SPEED
The machine speed can be set with the
speed dial located at the rear of the unit.
The numbers on the speed dial correspond
approximately with the spindle speeds:
1: 1800 OPM
2: 2400 OPM
3: 3000 OPM
USING THE POLISHER
5
If your workspace is so light that it can be moved by the rotating pad,
anchor it securely to prevent possible bodily injury.
a. Read and follow the directions supplied with the product (polishes, waxes,
cleaners, etc.)
b. Apply a small amount of the product directly to the polishing pad, or work surface
as directed by product manufacturer.
c. Grasp the polisher firmly with both hands.
One hand on auxiliary handle and one on
the motor housing.
d. Position the polisher with the polishing
pad against the work surface and then start
the polisher.
NEVER run or stop the tool when it is
not in contact with the work surface.
• Move the polisher back and forth in a sweeping
motion, over-lapping each previous pass. See diagram
on the right.
• DO NOT apply additional pressure. Allow the polisher
to work under its own weight.
• DO NOT mix products (wax, polish, cleaner, etc.) on
the same pad. Label each pad to prevent confusion.
XL
21mm
ORBIT
www.shurhold.com
4: 3600 OPM
5: 4200 OPM
6: 4800 OPM
BEGIN HERE
5
Publicité
Table des Matières
