Shurhold DUAL ACTION POLISHER PRO Manuel De L'utilisateur page 11

For best results, use Buff Magic and Buff Magic Pad and follow the steps below:
STEP 1
Choose the pad for the job. We recommend using Shurhold's Foam Buff Magic Pad. Be
sure to start the job with a clean, dry pad.
STEP 2
Use a clean, small paint brush and apply a series of X's to a small 2 foot square area. Do
not apply the Buff Magic to the pad.
STEP 3
Once the Buff Magic is on the surface, place the pad face directly on the surface of your
boat or vehicle and turn the machine on. Start at a speed of 2. Make sure you do not start
the machine until the pad is on the surface, as this will help to reduce slinging and mess
of the product.
STEP 4
As soon as the machine is on, use the following overlapping pattern. Do not apply a lot of
pressure, let the machine do the work for you.
STEP 5
You should slowly move through the overlapping
pattern a couple of times. If necessary, you can speed
up the tool to a 3 or 4. Remember to turn the tool off
before removing it from the surface.
STEP 6
Use a microfiber towel to remove any excess
material. If the surface has the showroom shine you
are looking for, then you can move on to the next 2
foot square area. If not, you have a deeper level of
oxidation and you may have to repeat these steps a
couple more times.
www.shurhold.com
BEGIN HERE
XL
21mm
ORBIT
11