Machine Components - Otto Office OX10 Notice D'utilisation

Check the machine and cable regu-
larly for damage. Switch the shred-
der off if it is damaged or not work-
ing correctly or before relocating or
cleaning it and disconnect it from
the mains.
– Keep the machine, the plug and cable away
from open fi re and hot surfaces. The ventila-
tion slots must not be blocked or covered
and there must be at least 5 cm space
between the shredder and any wall or furni-
ture.
– Disable the machine when not in use: dis-
connect the power plug from the mains and
cut the power cable.
Service work may only be carried
out by HSM Customer Service or by
the service technicians of our con-
tractual partners.
See page 2 for our customer ser-
vice addresses.
Notice Danger from improper use
Only operate this machine in accordance with
the instructions outlined in "Proper use".
8

3 Machine components

1 2 3 4 5 6 7
1 Shredded paper container
2 LED indicator
3 Sliding switch for operating mode
4 Safety notice
5 Feed opening for paper
6 Feed opening for CDs and cards
7 Cutting head
4 Setting up
WARNING
Danger of injury from sharp blades
on the underside of the device.
• Carefully place the cutting head
on the container for shredded
material.
• Connect the power plug of the
machine into a properly installed
socket.
Note: The document shredder can only be
switched on if it has been placed correctly on
the shredded material container belonging to it.
07/2011