Electrical Connections; Description Of The Controls; Using The Dehumidifier - DeLonghi DD95 Mode D'emploi

Electrical connections

Before connecting the appliance to the power supply, check the following:
• The mains power supply must correspond to the power supply shown on the rating plate.
• The power socket and the electrical circuit must be adequate to supply the appliance.
• The power socket must match the plug. If not, have the plug replaced by qualified personnel.
• The power socket must be adequately earthed.
The manufacturer accepts no responsibility if these safety regulations are not complied with.
This appliance is manufactured in compliance with EEC directive EN 55014 relative to the suppression of
radio interference.

Description of the controls

Pilot
lamp

Using the dehumidifier

1) Plug the appliance into the power socket. The pilot lamp lights to show that the appliance is switched on.
2) Check that the "Canister control system" pilot lamp is off.
3) Turn the humidostat knob to the desired position.
4) To switch off the appliance, turn the humidostat knob anti-clockwise to the "OFF" position.
Note:
For technical reasons, the humidity is expressed in levels rather than in degrees.
We recommend starting with the humidostat knob set to t"CONTINUOUS". When the humidity in the room
reaches the desired level, turn the knob slowly anti-clockwise until the appliance switches off. In this way,
the appliance is programmed to maintain the exact humidity level that you desire.
Canister control
system
Humidostat knob
13