Makita HR2650 Manuel D'instruction page 12

Using dust cup set
Optional accessory
Fit the dust cup set against the ceiling when operating
the tool.
NOTICE:
Do not use the dust cup set when drilling in
metal or similar. It may damage the dust cup set due to
the heat produced by small metal dust or similar.
NOTICE:
Do not install or remove the dust cup
set with the drill bit installed in the tool. It may
damage the dust cup set and cause dust leak.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Replacing filter of dust case
1. Remove the dust case while pressing down the
lever of the dust case.
► 1 . Lever
2. Insert the flat-blade screwdriver into the slots of
the filter cover to remove the filter case and filter.
► 1 . Flat-blade screwdriver 2. Filter case
3. Remove the filter from the filter case.
► 1 . Filter 2. Filter case
4. Attach a new filter to the filter case, and then
attach them to the dust case aligning the protrusion on
the filter case with the groove on the dust case.
1
12 ENGLISH
1
1
2
2