Important Safety Instructions; Installation Instructions; Unpack The Ice Maker; Location Requirements - Whirlpool WPGI1500XHS Guide D'utilisation Et D'entretien

WARNING
: To reduce the risk of fire, electric shock, or injury when using your ice maker, follow these basic
precautions :
■
Plug into a grounded 3 prong outlet.
■ Do not remove ground prong.
■
Do not use an adapter.
■ Do not use an extension cord.

Unpack the Ice Maker

WARNING
Excessive Weight Hazard
Use two or more people to move and install ice maker.
Failure to do so can result in back or other injury.
Removing Packaging Materials
Remove tape and glue from your ice maker before using.
■ To remove any remaining tape or glue, rub the area briskly
with your thumb. Tape or glue residue can also be easily
removed by rubbing a small amount of liquid dish soap over
the adhesive with your fingers. Wipe with warm water
and dry.
■
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your ice maker.
Cleaning Before Use
After you remove all of the packaging materials, clean the inside
of your ice maker before using it. See the cleaning instructions in
the "Ice Maker Care" section.

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

INSTALLATION INSTRUCTIONS

■ Disconnect power before cleaning.
■ Disconnect power before servicing.
■ Replace all parts and panels before operating.
■ Use two or more people to move and install ice maker.

Location Requirements

■
To ensure proper ventilation for your ice maker, the front side
must be completely unobstructed. The unit may be closed-in
on the top and 3 sides, but the installation should allow the
ice maker to be pulled forward for servicing if necessary.
■ Installation of the ice maker requires a cold water supply inlet
of ¹⁄₄" (6.35 mm) OD soft copper tubing with a shutoff valve
and either a gravity-drain system or condensate pump to
carry the water to an existing drain.
■
Choose a well ventilated area with temperatures above 55°F
(13°C) and below 100°F (38°C). Best results are obtained
between 70°F (21°C) and 90°F (32°C).
■ This unit must be installed in an area protected from the
elements, such as wind, rain, water spray, or drip.
■ When installing the ice maker under a counter, follow the
recommended opening dimensions shown. Place electrical
and plumbing fixtures in the recommended location as
shown.
NOTE: Do not kink or pinch the power supply cord between
the ice maker and cabinet.
34"
(86.4 cm)
Min.
34 1/2 "
(87.6 cm)
Max.
(60.1 cm)
A. Recommended location for electrical
and plumbing fixtures
B. Floor level
■ You should choose a location where the floor is even. It is
important for the ice maker to be level in order to work
properly. If needed, you can adjust the height of the ice maker
by changing the height of the leveling legs. See "Leveling."
11 1/2 "
(29.2 cm)
28 1/2 "
(72.4 cm)
9"
1/2
3 "
(22.9 cm)
(8.9 cm)
24"
15"
(38.1 cm)
A
B
3