Environmental Instructions - Würth 0701 330 001 Traduction Des Instructions De Service D'origine

Technical data
Parameter
Max. workpiece length
Max. working load limit 15 kg*
*In the case of long or heavy workpieces, use addi-
tional workpiece holders.
Assembly
Fig. I: Pressure screws
Screw the four pressure screws [2] supplied into
■
the weld nuts of the top section [1].
Fig. II: Support feet
Push the four support feet [3] into the pipe ends
■
of the top section and align according to floor
unevenness until the base frame is standing
stably and horizontally.
Screw the support feet down tightly with the four
■
pressure screws [2].
Fig. III: Workpiece holder
Insert the T-shaped part [4] into the upright
■
square pipe [5] and fix with a pressure screw.
Insert the workpiece holder into the front, hori-
■
zontal square pipe to the left on the base frame
and fix it with the pressure screw [6].
Fig. IV: Longitudinal stop
Fix the adjusting screw and lock nut [7] into the
■
T-shaped pipe [8].
Push the longitudinal stop into the square
■
pipe [9].
Push the round bar laterally into the top section
■
and fix it using the clamping lever [10].
Fig. V: Fixing the MK2400 hacksaw to the
metal stand
Guide the hacksaw over the base frame and
■
under the bracket [11] and fix it using both side
locking screws [13].
Note
Pay attention to the recess in the
bracket profile frame for the chippings
drawer.
Fix the longitudinal stop using the clamping
■
lever [10] to 0 mm.
Unscrew the adjusting screw [7] until the
■
hexagon is touching the carbide tooth of the saw
blade.
Fix the adjusting screw using the lock nut.
■
8
0701 330 001
150 cm*

Environmental instructions

Do not throw the device away with
normal domestic waste. Dispose of
the device via an approved waste
disposal company or via your local
authority waste disposal facility.
Observe the currently valid regula-
tions. In case of doubt, contact your
waste disposal facility. Dispose of all packaging in
an environmentally compatible manner.
Warranty
We provide a warranty for this Würth device from
the date of purchase and in accordance with the
legal/country-specific regulations (proof of purchase
through invoice or delivery note).
Damage that has occurred will be corrected either
by replacement or by repair. Damage caused by
improper handling is not covered by the warranty.
Claims under warranty can only be accepted if
the device is returned fully assembled to a Würth
agency, your Würth sales representative or an
authorised Würth customer service workshop.
Subject to technical changes without prior notice.
We accept no liability for printing errors.
Accessories and spare parts
If in spite of careful manufacturing and test proce-
dures, the device becomes faulty, a repair by Würth
masterService should be arranged.
With any enquiries or spare parts orders, always
quote the article number as given on the device type
plate.
The latest spare parts list for the device is available
online at http://www.wuerth.com/partsmanager.
Alternatively, contact your local Würth agency for a
hardcopy.