Publicité
ScanTemp 380 – Infrared Thermometer
Safety Cautions:
EMC/RFI
• Protect the unit from EMI (Electro
Magnetic Interference) from induc-
tion heaters and microwave ovens
and Electro Static Discharge. Rea-
dings may be affected if the unit is
operated within a radio frequency
electromagnetic field strength of
approximately 3 volts per meter, but the performance of
the instrument will not be permanently affected.
Attention:
• Do not look directly into the laser beam – permanent
eye damage may result.
• Keep out of the reach of children
• Protect the unit from "thermal shock" (caused by large
or abrupt ambient temperature changes).
• Do not leave the unit on or near objects of high tempe-
rature.
• Not recommended for taking human temperature.
Battery:
Battery OK
Battery almost
exhausted
• Change the battery when the middle or right battery
power symbol appears on the display (2 x 1,5 Volt AAA).
• Remove the battery compartment sliding the cover
downward. Attention: Confirm the unit is power off
before changing battery.
• Do not dispose of empty batteries in household waste.
Please do not dispose of old electronic devices and used
batteries in household waste. To protect the environ-
ment, take them to your retail store or to nearest civic
amenity site to be disposed of according to national or
local regulations.
8
Battery
exhausted
replace
replace
soon
at once
ScanTemp 380 – Infrared Thermometer
Trouble Shooting:
°C
°C
The temperature is out of the permissible measuring range.
Er2:
The ambient temperature is rapidly changing.
Er3:
The ambient temperature is beyond
0..+50°C (32..122°F).
Please wait 30 minutes until the instrument has settled at the
new ambient temperature.
All other error messages:
Confirm the unit is power off before.
Remove the battery for 1 minute, then
repower it.
If the error message does not disappear,
contact the retailer for further service
Reminders:
• Not recommended for use in measuring shiny or polished
metal surfaces (stainless steel, aluminum, etc.)
• The unit cannot measure through transparent surfaces
such as glass or plastic. It will measure the surface tem-
perature of the glass instead.
• Steam, dust, smoke, etc., can prevent accurate measure-
ment by obstructing the unit's optics.
Care and Cleaning:
• The Sensor Lens is the most delicate part of the thermo-
meter. Please protect the sensor part from dirt. Gently
clean it with a soft cloth moistened with water or medi-
cal alcohol.
• Avoid splashes and spills on the unit.
• Store at a temperature of between -20°C to +65°C.
9
Publicité
